Freebsd ath driver

The ath0 interface then does not show up in ifconfig -a, because of the errors. So I'm not sure how, on a RELEASE system, what you're suggesting could work. If the ath driver attached properly, yes, if_ath_load would in fact start my card automatically on boot, but the driver can't attach, so trying to attach on bootup isn't very helpful. The ath device driver first appeared in FreeBSD CAVEATS Revision A1 of the D-LINK DWL-G and DWL-G are based on an Intersil PrismGT chip and are not supported by this driver. BUGS The driver does not fully enable power-save operation of the chip in station mode; consequently power use is suboptimal (e.g. on a laptop). Ed: I took recompiled and got the same issue. If I use the LATEST mad distro I get some compile bugs (ath_desc_status was moved into ath_desc structure in ah_desc.h) which I can't completely work around (apparently the API into the HAL has changed as well).

ath (4) [freebsd man page] The ath driver provides support for wireless network adapters based on the Atheros AR, AR, AR, AR and AR programming APIs. These APIs are used by a wide variety of chips; most all chips with a PCI and/or CardBus interface are supported. Provided by: freebsd-manpages__all NAME ath — Atheros IEEE wireless network driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device ath device ath_hal options AH_SUPPORT_AR device ath_rate_sample device wlan Alternatively, to load the driver as a module at boot time, place the following line in www.doorway.ru(5. FreeBSD Atheros ath driver bugs If you are interested in reviewing FreeBSD Atheros driver bugs see the FreeBSD ath bugs page This is a static dump of the old wiki, taken after locking it in January

Development - Ongoing driver development of the Atheros HAL wireless driver in FreeBSD. Maintainer/lead of the FreeBSD net wireless stack. The ath driver provides support for wireless network adapters based on the Atheros AR, AR, The ath device driver first appeared in FreeBSD 25 វិច្ឆិកា Currently I'm sitting at the terminal on my new freebsd laptop! step is to update the www.doorway.ru file so the kernel loads the driver.